Trough Cover Detail – 163 viewsSupport pegs for cover. Lucite window for hook-up camera can also be seen.
|
|
Trough Cover Detail – 176 viewsCover supported by rounded tabs welded in to top of trough, and aluminum receiver plates that mate to round pegs at trough head.
|
|
Trough Cover Detail – 175 views1/8" aluminum sheet stiffened by two 4" aluminum I-beams running its length
|
|
Flat Deck with Trough Cover Installed – 157 views
|
|
Flat Deck with Trough Cover Installed – 175 views
|
|
Flat Deck with Trough Cover Installed – 177 viewsLocking T-handle
|
|
Flat Deck with Trough Cover Installed – 178 views
|
|
1" Hitch Plate -- FOR SALE – 193 views
|
|
1" Hitch Plate -- FOR SALE – 200 views
|
|
1" Hitch Plate -- FOR SALE – 207 viewsEdge view showing underside gussetted attaching brackets to left, and blocking "skin" to right in picture. This hitch plate with brackets probably weighs about 300 lbs, as determined by our efforts to pick it with the tractor bucket.
|
|
1" Hitch Plate -- FOR SALE – 234 viewsUnderside of hitch plate. It is pre-drilled for three gooseneck ball settings, and still has a good quality RV plug attached. Should be ready to bolt in to any VNL frame.
|
|
1" Hitch Plate -- FOR SALE – 256 viewsThis shows the plate installed between the frame rails prior to building the RV body. It is supported by underside gussetted brackets bolted to the rails. The over-rail brackets attach a plate steel skin that prevents chains/pigtail/etc. from getting hung up in the "C" space above the hitch plate under the rail lip. This skin is not providing structural support; the hitch and trailer weight is carried by the hitch plate's underside brackets..
|
|
Finished Body – 243 views
|
|
Finished Body – 234 viewsJeff Frey and Tyler Boote, The Fab Shop
|
|
Finished Body – 248 views
|
|
Finished Body – 222 viewsHooked up and ready to go. Might have to adjust the gooseneck coupler to level when I get on even ground.
|
|
Finished Body – 235 viewsHooked up and ready to go. Might have to adjust the gooseneck coupler to level when I get on even ground.
|
|
Finished Body – 235 views12V lights actuated by the door switch. Quick disconnect discharge and pump switch in this lower box.
|
|
Finished Body – 244 viewsNot sure what went wrong with the lighting - the flash worked, maybe too well!
|
|
Finished Body – 242 views
|
|
Finished Body – 239 viewsJeff Frey did most of the fabrication and Tyler Boote engineered and managed the project through the shop.
|
|
Finished Body – 258 viewsFirst trip tomorrow!
|
|
Finished Body – 243 views
|
|
Finished Body – 248 viewsI'll make some dividers for the shallow boxes
|
|
Finished Body – 257 viewsAir chuck for tires
|
|
|
|
